Silicon Laboratories CP2112-EK Guide de l'utilisateur

Rev. 0.3 7/13 Copyright © 2013 by Silicon Laboratories CP2112-EKCP2112-EKCP2112 EVALUATION KIT USER’S GUIDE1. Kit ContentsThe CP2112 Evaluation Kit c

CP2112-EK10 Rev. 0.37. Target BoardThe CP2112 Evaluation Kit includes an evaluation board with a CP2112 device pre-installed for evaluation andprelim

CP2112-EKRev. 0.3 117.2. Universal Serial Bus (USB) Interface (P1)A Universal Serial Bus (USB) connector (P1) is provided to facilitate connections t

CP2112-EK12 Rev. 0.38. SchematicFigure 10. CP2112 Evaluation Board Schematic

CP2112-EK13 Rev. 0.3DOCUMENT CHANGE LISTRevision 0.1 to Revision 0.2 Updated Figure 1. Updated "6. CP2112 Windows Application" on page 4.

CP2112-EK14 Rev. 0.3CONTACT INFORMATIONSilicon Laboratories Inc.400 West Cesar ChavezAustin, TX 78701Tel: 1+(512) 416-8500Fax: 1+(512) 416-9669Toll Fr

CP2112-EK2 Rev. 0.34. CP2112 Hardware Interface1. Connect the CP2112 evaluation board to a PC as shown in Figure 1.2. Connect one end of the USB cabl

CP2112-EKRev. 0.3 35. CP2112 Software InterfaceThe CP2112 is an HID device that uses the standard HID functions available in the operating system. To

CP2112-EK4 Rev. 0.36. CP2112 Windows ApplicationThe HID SMBus Example application uses the Windows CP2112 HID-to-SMBus DLL to transmit and receive da

CP2112-EKRev. 0.3 56. To read data from an SMBus device (non-addressed mode):a. Click the Data Transfer tab.a. Enter the slave address and the number

CP2112-EK6 Rev. 0.37. To read data from an EEPROM or similar device (addressed mode):a. Click the Data Transfer tab.e. Enter the slave address, the nu

CP2112-EKRev. 0.3 78. To write data over the SMBus interface:a. Click the Data Transfer tab.i. Enter the Slave address and data (in hex) in the Write

CP2112-EK8 Rev. 0.39. The Pin Configuration tab enables configuration of the GPIO and special functions (TX Toggle, RX Toggle, and Clock Output).a. Cl

CP2112-EKRev. 0.3 910. The Customization tab allows for programming the One-Time-Programmable (OTP) parameters of the device. These parameters can onl