Silicon Laboratories Si2415 Spécifications télécharger pdf (Page 37)

Si2457/34/15/04

Rev. 1.3 37

\U Serial mode—causes a low pulse (25 ms) on RI and DCD. INT to be the inverse of ESC. RTS to be

inverse of CTS

Parallel mode—causes a low pulse (25 ms) on INT

This command terminates with a RESET

\Vn Connect message type

\V0 Report connect message and protocol message

\V2 Report connect message only (exclude protocol message)

\V4 Report connect and protocol message with both upstream and downstream connect rates.

Table 11. Extended AT\ Command Set (Command Defaults in Bold) (Continued)

Command Action

Notes:

1. When in autobaud mode, \B0, \B1, and \P1 will not be detected automatically. The combination of \B2 and \P3 will be

detected. This is compatible with seven data bits, no parity, two stop bits. Seven data bits, no parity, one stop bit may be

forced by sending AT\T17\B1.

2. The autobaud feature does not detect this rate.

3. Default is \T9 if a pulldown resistor is connected to the autobaud strap pin; otherwise, the default is \T16.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 59 60

Pas de commentaire

Silicon Laboratories Si2415 Spécifications Page 37