Silicon Laboratories Stepper Machine Manuel d'utilisateur télécharger pdf (Page 8)

_________________________________________8_______________________________________

This error happens only during updating from version 4.34 or earlier. This is because

of a bug in the previous version. At this point the previous version is uninstalled but installation of

the new version cannot continue automatically. Click OK.

Next screen will inform that current installation was not finished successfully.

Click “Finish” to close current installation and run it again (go to point 1). Next time

installation will run correctly.

7. Click Finish when Setup is completed.

8. Now it is time to connect machine for the first time. Connect the machine using the USB

cable provided to any USB port available on the computer. Following messages may appear

on the right bottom corner of the screen:

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Pas de commentaire

Silicon Laboratories Stepper Machine Manuel d'utilisateur Page 8